Filter
Top Products
Assembly 35
MAN0805 (4/30/2009)
Install Wheel and Hub (BW180HD)
1. Insert wheel hub into outside of wheel yoke arm (1)
and align holes.
2. Secure into position using cap screw (54) and
flanged lock nut (55).
3. Attach wheel to hub using five lug nuts. Install the
chamfered side of the lug nut toward the inside for
steel rim for pneumatic tires and rims. Tighten to 75
lbs-ft. Check that tire air pressure is a maximum of
40 psi.
NOTE: Install the flat side of the nut toward the
inside for solid tires and aircraft tires (shown).
4. Install optional dual wheel and hub to inside of
wheel yoke arm.
NOTE: Pneumatic, notat, and airplane tires are
available for this cutter. See page 62 for parts list.
Figure 26. Center Section Wheel and
Hub Installation
Install Tongue (BW180HD)
1. Attach tongue (24) to center section using two
tongue pivot pins (33) and cotter pins (70).
2. Attach attitude rod (6) to lug on tongue and secure
with clevis pin (34), washer (35), and cotter pin
(66).
3. Attach parking jack (22) to the side of the tongue.
4. Attach safety chain (8) to the bottom of center
gusset and secure with cap screw (40), washer
(38), and lock nut (39).
Figure 27. Tongue Installation
1. Center wheel yoke arm
54. 1/2" NC x 3" HHCS GR5
55. 1/2" NC Flange lock nut
6. Attitude rod
8. Safety chain
22. Parking jack
24. Tongue
33. Tongue pivot pin
34. Clevis pin, 1" x 2.26"
35. Washer, flat 1"
38. Washer, flat 3/4" x 2" x 3/8"
39. 3/4" NC Lock nut
40. 3/4" NC x 2-1/2" HHCS GR5
66. Cotter pin, 1/4" x 1-1/2"
70. Cotter pin, 3/16"x 1-1/2"