Filter
Top Products
15
WOODS
MAINTENANCE
CLEANING MACHINE
Clean the machine after use. Compressed air is
recommended. Do not use a pressure washer. The
machine will run cooler and last longer if kept free of
clippings and other debris. A clean machine also re-
duces the risk of re due to accumulation of combus-
tible debris and chaff.
Brush or blow clippings and debris off the cutterdeck
and engine deck. DO NOT use a pressure washer.
WASHING MACHINE
CAUTION: Improperly washing a machine can cause
water to enter bearings and other components. This
can greatly reduce component life.
– Do not use a pressure washer. Do not direct
water at bearings or seals. High pressure water
can blow past seals and enter sealed bearings.
– Allow the machine to cool down before washing.
Water on a warm machine can be sucked into
sealed bearings as they cool.
– Avoid getting electrical connections wet. Water
can cause electrical faults and corrosion of elec-
trical components.