Filter
Top Products
23
PN-51210 (Rev. 7/98)
H
YDRAULIC
F
EED
O
PERATION
I
NSTRUCTIONS
1. Engage the PTO. Bring the chipper up to operating speed. See the
operation section for starting, operation, and stopping instructions.
2. Engage the hydraulic feed by moving the control arm as shown in figure
11 below. The feed rate increases as the arm is moved in the forward
direction.
3. Feed the branch (up to eight inches in diameter).
4. Reverse the feed by moving the control arm in the reverse direction if the
chipper jams. Remove the branch and rotate it before reinserting it into the
chute.
Please read and
follow all safety
instructions in this
manual. Failure to
operate the chipper in
accordance with the
safety instructions
MAY RESULT IN
PERSONAL INJURY!
Figure 11
Feed Control
Lever
s
Forward
s
Reverse
Neutral
Hydraulic Schematic
Parts listed on page 28.
Control Arm Operation