Filter
Top Products
13
• Secure the impeller assembly to the crankshaft
using the hex bolt, lock washer, and flat washer
previously removed. Torque the bolt to 550 in. lbs.
to 700 in. lbs.
• Place the housing blades against the inner
housing. See Figure 16.
Figure 16
• Place the outer housing against the inner housing.
Insert two screwdrivers into the holes to hold the
blades in place while attaching the outer housing.
See Figure 17.
• Secure with the fourteen self tapping screws that
were previously removed and insert all screws first
before tightening.
• Reassembled following the previous steps in
reverse order.
Figure 17
Storing Your Chipper Shredder Vacuum
• Clean the equipment thoroughly.
• Wipe equipment with an oiled rag to prevent rust.
• Refer to engine manual for correct engine storage
instructions
• Store unit in a clean, dry area. Do not store next to
corrosive materials such as fertilizer.
WARNING: Never store the machine or
fuel container indoors where there is an
open flame, spark, or pilot light such as on
a water heater, furnace, clothes dryer, or
other gas appliance.
Inner
Housing
Housing
Blades
Holes for
Screwdrivers
Outer
Housing