White Outdoor 1150W Snow Blower User Manual


 
13
Drain the gasoline from the snow thrower, or place
a piece of plastic film under the gas cap.
Tip the snow thrower up and forward so that it rests
on its auger housing.
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
Roll the front and rear auger belts off the auger
drive pulley. See Figure 14.
Figure 14
Unhook the idler spring from the hex bolt on the
auger housing. See Figure 14.
Back out the stop bolt until the support bracket
rests on the auger pulley.
NOTE: Loosening the six nuts that connect the frame to
the auger housing may aid in belt removal.
Lift the rear auger belt from the auger pulley, and
slip the belt between the support bracket and the
auger pulley. Repeat this step for the front auger
belt.
Replace both auger drive belts by following
instructions in reverse order.
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
Drive Belt
Follow the first four steps of the instructions for
servicing the auger belts.
Pull the idler pulley up and lift the belt off the wheel
drive pulley and friction wheel disc. See Figure 14.
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 15.
Slip the belt between the friction wheel and drive
disc. Remove and replace the belt. Reassemble
following the instructions in reverse order.
NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled.
Figure 15
Replacing Friction Wheel Rubber
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.
Tip the snow thrower up and forward, so that it rests
on the housing.
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
Remove the click pin that secures the left wheel to
the axle and slide the wheel from the axle.
Remove the four screws securing the left drive
cover to the frame. Remove the drive cover. See
Figure 16.
Auger
Pulley
Drive
Pulley
Drive
Belt
Idler
Pulley
Idler
Pulley
Auger
Belts
Frame
Support
Bracket
Spring
Auger Housing
Idler Spring
Front
Auger Belt
Rear
Auger
Belt
Support
Bracket
Frame
Drive Plate
Friction
Wheel
Stop Bolt
Support Bracket
Auger Pulley