Filter
Top Products
6
SECTION 5: UNPACKING
Removing Unit From Carton
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open
carton.
• Remove loose parts if included with unit (i.e., owner's manual, etc.). See Figure 1.
FIGURE 1
• Cut along dotted lines and lay carton down flat. Remove packing material.
• Roll or slide unit out of carton. Check carton thoroughly for loose parts. See Figure 1.
NOTE: Make sure not to crimp the cables while removing the loose parts or the entire unit from the carton.
NOTE: Reference to right or left hand side of the mower and/or front or behind the mower is observed from
the operating position.
SECTION 6: SETTING UP MOWER
Tools Required
• Pair of Pliers
• Funnel
Disconnecting Spark Plug
• Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and ground
it against the engine. See Figure 2.
• Attach rubber boot to a bolt on the engine to ground.
FIGURE 2
O
W
N
E
R
’
S
M
A
N
U
A
L
Spark Plug
Wire
Rubber Boot
Spark Plug