Filter
Top Products
6
SECTION 5: ASSEMBLY INSTRUCTIONS
IMPORTANT: This unit is shipped WITHOUT
GASOLINE or OIL. After assembly, see separate
engine manual for proper fuel and engine oil
recommendations.
NOTE: Left and right is determined from the
operator’s position, standing behind the tiller.
TOOLS REQUIRED FOR ASSEMBLY
Adjustable Wrenches
Pair of Pliers
TO REMOVE UNIT FROM CARTON
1. Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to
open carton.
2. Remove loose parts included with unit (i.e.,
operator’s manual, etc.).
3. Cut along dotted lines and lay carton down flat.
4. Remove packing material.
5. Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
6. Extend control cable and lay on the floor. Be
careful not to bend or kink control cable.
Figure 3
ATTACHING DEPTH STAKE ASSEMBLY
1. Tip the tiller forward so it rests on front
counterweight.
2. Raise the tine shield hinge flap assembly.
Remove "T" knob, flat washer and hex bolt from
depth stake. Insert the depth stake assembly in
front of spacer (under the tine shield) and up
through the tine shield assembly as shown in
Figure 3.
3. Insert clevis pin through the tine shield and the
second hole from top of the depth stake. Secure
with hairpin clip.
4. Insert hex bolt into the top hole of the depth
stake assembly. Place flat washer on hex bolt
and thread “T” knob onto the hex bolt. See
Figure 3. Tighten securely.
5. Tip the tiller back down so it rests on the depth
stake (transport position).
ATTACHING THE HANDLE ASSEMBLY
Figure 4
1. Remove top two bolts and flange lock nuts from
handle mounting brackets as shown in Figure 4.
Do not remove the bottom bolt and nut.
2. Place handle assembly in position between the
handle mounting brackets. See Figure 4.
3. Line up holes in handle with holes in handle
mounting brackets. Secure with hardware
removed in step 1.
T-Handle Hex Bolt
Washer
Depth
StakeStake
T-Knob
Hex Bolt
Washer
Clevis Pin
Hairpin Clip
Depth Stake
Remove
Handle
Ass’y
Handle
Bracket