Filter
Top Products
7
S
Avoid heavy contact w ith solid objects that
might stop the tines. If heavy contact oc-
curs, stop the engine and inspect the unit
for damage.
S
Never operate the cultivator without the tine
cover in place and properly secured.
S
Keep the tines and guard clear of debris.
S
After str iking aforeign object, st op theengine,
disconnect t hesparkplug andinspect t hecul-
tivator for damage. Repair before restarting.
S
Disconnect attachment from the drive en-
gine before cleaning the tines with a hose
and water to remove any build--up. Oil the
tines to prevent rust.
S
Always wear gloves when servicing or
cleaning the tines. The tines become very
sharp from use.
S
Do not run unit at high speed unless culti-
vating.
HEDGE TRIMMER SAFETY
DANGER:
RISK OF CUT; KEEP
HANDS AWAY FROM BLADE -- Blade
moves momentarily after the trigger is re-
leased. Do not attempt to clear away cut ma-
terial when the blade is in motion. Make sure
the switch is in the OFF position, the spark
plug wire is disconnected, and the blade has
stopped moving before removing jammed
material from thecutting blade. Donot grabor
hold the unit by the cutting blade.
Allow blades to stop
before removing
them from the cut.
Blades move
momentarily
after the
trigger is
released.
WARNING:
Inspect the area before
starting the unit. Remove all debris and hard
objects such as rocks, glass, wire, etc. that
can ricochet, be thrown, or otherwise cause
injury or damage during operation.
S
Do not use a cutting blade that is bent,
warped, cracked, broken or damaged in any
other way. Have worn or damaged parts re-
placed by your authorized service dealer.
S
Always keep unit in front of your body.
Keep all parts of your body away from the
cutting blade.
S
Keep the cutting blade and air v ents clearof
debris.
SNOW THROWER SAFETY
WARNING:
Keep hands and feet
away from the rotor when starting or running
the engine. Never attempt to clear the rotor
with the engine/motor running. Stop engine
and disconnect spark plug before unclogging
snow or debris from discharge chute or when
adjusting vanes.