Filter
Top Products
7
Choke
Lever
S
t
a
r
t
e
r
H
a
n
d
l
e
Primer Bulb
5. Pull starter rope handlesharply u ntil engine
sounds as if it is trying to start, but do not
pull rope more than 6 times.
6. As soon asengine sounds asif itis tryingto
start, move choke lever to HALF CHOKE
position.
7. Pull starter rope sharply until engine runs,
but no m ore than 6 pulls.
NOTE:If theengine doesn’t start after 6
pulls (at the HALF CHOKE position),
move the choke lever to the FULL
CHOKE position and press the primer
bulb 6 times. Squeeze and hold the
throttle trigger and pull the starter rope 2
more times. Move the choke lever to the
HALF CHOKE position andpull thestart-
er ropeuntil theengine runs, butnomore
than 6 pulls. If the engine still doesn’t
start, it is probably flooded. Proceed to
STARTING A FLOODED ENGINE.
8. Once theengine starts,allow ittorun10 se-
conds, then move the choke lever to the
RUN position. Allow the unit to run for 30
more seconds atRUN before releasing the
throttle trigger .
NOTE: If enginedies with the choke le-
ver in the RUN position, move the choke
lever to the HALF CHOKE position and
pull the rope until en gine runs, but no
more than 6 pulls.
STARTING A WARM ENGINE
1. Move the choke lever to the HALF
CHOKE position.
2. S queeze and hold the throttle trigger.
Keep throttle trigger fully squeezed until
the engine runs smoothly.
3. Pull starter rope sharply until engine runs,
but no m ore than 6 pulls.
4. Allow engineto run 15seconds, thenmove
the choke lever to the RUN position.
NOTE: If engine has not started, pull starter
rope 5more pulls. Ifengine still does not run,
it is probably flooded.
STARTING A FLOODED ENGINE
Flooded engines can be started by placing
thechokeleverintheRUNposition; then,pull
the rope to clear the engine of excess fuel.
This could require pulling the starter handle
many times depending on how b adly the unit
is flooded. Ifthe unitstill doesn’t start, refer to
TROUBLESHOOTING TABLE or call
1-800-554--6723.
OPERATING INSTRUCTIONS
It i s recommended that the engine not be
operated for longer than 1 minute at full
throttle.
OPERATING POSITION
Cut from your left to your right.
A
L
W
A
Y
SWE
A
R:
Eye protection
Long pants
Heavy shoes
WARNING: Alwayswear eyeprotec-
tion. Never lean over the trimmer head.
Rocks ordebris canricochetorbethrowninto
eyes and face and cause blindness or o ther
serious injury.
Do not run the engine at a higher speed than
necessary. The cutting line will cut efficiently
when the engine is run at less than full throttle.
At lower speeds, there is less engine noise and
vibration. The cutting line will last longer and will
be l ess likely to “weld” onto the spoo l.
Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
To stop engine:
S Release the throttle trigger.
S Push and hold the STOP switch in the
STOP position until the engine stops.
TRIMMER LINE A DVAN CE
Thetrimmerlinewilladvanceapproximately2
inches ( 5 cm) each time the bottom of the
trimmerheadis tappedonthegroundwiththe
engine running at full throttle.
The most ef ficient line length is the maximum
length allowed by the line limiter .Always keep
the shield in place when the tool is being oper-
ated.
To advance line:
S Operate the engine at full throttle.
S Holdthetrimmerheadparalleltoandabove
the grassy area.
S Tap the bottom of the trimmer head lightly on
the g round one time. Approximately 2 inches
(5 cm) of line will be advanced with each tap.