Filter
Top Products
7
TROUBLE CAUSE REMEDY
Semi-automatic
head st ops
under a load or
does not turn
when switch is
pressed.
1. Allow tip of line to do the cutting.
2. Cont act your authorized service dealer .
3. Check Br eaker Box.
4. Remove debris.
Line does not
advance or
breaks while
cutting.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only .065 in. (1.65mm) dia. line.
4. Remove cover and pull 4 in.
(10 cm) of line out of head.
5. Clean unit.
Line welds onto
spool.
1. Use only .065 in. (1.65mm) dia. line.
2. Replace with correct spool.
3. Cut with t ip of line fully e xtended.
Line releases
continuously.
1. Check line routing.
2. Replace spool.
Line pulls back
into head.
1. Too little line o utside
of head.
2. Line size incorrect .
1. Remove cover and pull 4 in .
(10 cm) of line outside of head.
2. Use only .065 in. (1.65 mm) dia. line.
TROUBLESHOOTING TABLE
1. Line improperly
routed in head.
2. Spool damaged.
1. Line size is incorrect.
2. Incorrect spool.
3. Line is being crowded
against material being
cut.
1. Line improperly rout e d
in head.
2. Line improperly
wound onto spool.
3. Incorrect line size
4. Not enough line
outside of head.
5. Dirt buildup on unit.
1. Crowding trimmer line
against material being
cut.
2. Electrical failur e.
3. Thrown circuit breaker .
4. Debris stopping head.
Line usage is
excessive.
1. Check line routing.
2. Replace spool.
3. Cut wit h tip of line fully extended.
4. Replace spool.
1. Line im properly routed
in head.
2. Line size is incorrect.
3. Crowding line against
material being cut.
4. Spool worn or damaged.
WARNING: Alwaysstop unitanddisconnect fromthe powersourcebefore
performingallof therecommended remedies below exceptremedies thatre-
quire operation of the unit.