Weed Eater 545146904 Blower User Manual


 
-- 5 --
ASSEMBLY
WARNING: Stop engineand besure
the impeller blades havestopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating b lades can cause
serious injury . Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING: If you receive your unit
assembled, check each step to insure your
unit is properly assembled and all fasteners
are s ecure. Follow all safety information in
the manual and on the unit.
D A standard screwdriver is requiredfor as-
sembly.
BLOWER TUBE ASSEMBLY
1. Alignthe ribontheupper blower tubewith
the groove in t he blower outlet; slide the
tube into place.
NOTE: Knob must be loose enough to allow
blowertubetobeinsertedinbloweroutlet.Loos-
en knob by turning counterclockwise.
Blower Outlet
Rib
Groove
2. Securethetubeby turningtheknobclock-
wise.
3. Align the slots on the lower blowe r tube
with the tabs on the upper blower tube.
Upper Blower
Tube
Tab
Slot
Lower Blower
Tube
4. Slidethe lowerblower tubeonto theupper
blower tube.
5. Turnthelower blower tubeclockwiseuntil
a click is felt to secure the lower blower
tube to the upper blower tube.
NOTE: When the upper and lower blower
tubes are assembled t ogether properly, the
arrows on both tubes will be aligned.
6. To remove the tubes, turn the knobcoun-
terclockwise to loosen the tubes; remove
the tubes.
HIGH --SPEED NOZZLE ASSEMBLY
When greater air speed is des ired, use the
high--speed nozzle.
1. Align the slots on the nozzle with the tabs
on the lower blower tube.
High--Speed
Nozzle
Tab
Slot
Lower Blower
Tube
2. Slide the nozzle onto the lower blower tube.
3. Turn the nozzle clockwise until a click is
felttosecurethenozzleto thelowerblow-
er tube.
VACUUM BAG ASSEMBLY
1. Open the zipper on the vacuum bag and
insert the elbow tube.
2. Push the small end of the elbow tube
through the small opening in the bag.
Small Opening
Zipper
Opening
Elbow
Tube
Rib
NOTE: Make sure edge of the small opening
is flushagainsttheflared areaoftheelbowtube,
and the rib on the elbow tube is on the bottom.
3. Closethezipperonthebag.Makesurethe
zipper is closed completely.
4. Remove blower tubes from engine.
Rib
Groove
5. Inserttheelbowtubeintothebloweroutlet.
Make sure elbow tube rib is aligned with
the blower outlet groove.
6. Turnknobclockwisetosecureelbowtube.
VACUUM TUBE ASSEMBLY
WARNING: Stopengine andbe sure
the impeller blades havestopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or rem ove the vacuum or