Filter
Top Products
7
Trimming
3 inches (8 cm)
above ground
SCALPING -- The scalping technique re-
moves unwanted vegetationdown to the
ground. Hold the bottom o f the trimmer head
about 3 inches (8 cm) abo ve the ground a nd
atanangle.Allowthetipofthelinetostrikethe
ground aroundtrees, posts, monuments,etc.
This technique increases line wear.
Scalping
MOWING -- Your trimmer i s ideal for mowing
in places conventional lawn mowers cannot
reach. In the mowing position, keep the line
parallel to the ground. Avoid pressing the
head into the ground as this can scalp the
ground and damage the tool.
Mowing
SWEEPING-- Thefanning actionof therotat-
ing line can be used for a quick and easy
clean up. Keep the line parallel to and above
the surfaces being swept and move the tool
from side to side.
Sweeping
MAINTENANCE
WARNING: Disconnect t he spark
plug before performing maintenance except
for carburetor adjustments.
HELPFUL TIP
IMPORTANT: Have all
repairs other than the rec-
ommended maintenance
described in theinstruction
manual performed by an
authorized service dealer.
If any dealer other than an authorized
service dealer performs work o n the
product,WEED EATER m aynot pa yfor
repairs under warranty. It is your re-
sponsibility to maintain and perform
general maintenance.
CHECK FOR LOOSE
FASTENERS AND PARTS
S Spark Plug Boot
S Air Filter
S Housing Screws
S Assist Handle Screws
S Debris Shield
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for re-
placement o f damaged or worn parts.
S STOP Switch -- EnsureSTOP switchfunc-
tions properly by pushing and holding the
switchin theSTOP position.Make sureen-
gine stops. Restart engine and continue.
S Fuel Tank -- Discontinue use of unit if fuel
tank shows signs of damage or leaks.
S Debris Shield -- Discontinue use of unit if
debris shield is damaged.
INSPECT AND CLEAN UNIT AND
LABELS
S After each use, inspect complete unit f or
loose or damaged parts. Clean the unit and
labels using a damp cloth with a mild deter-
gent.
S Wipe of f unit with a clean dry cloth.
CLEAN AIR FILTER
A dirty air filter decreases engine perform-
ance and increases fuel consumption and
harmful emissions. Always clean after every
5 hours of operation.
1. Clean the air filt er cover and the area
around it to keep dirt from falling into the
carburetor chamber when the c over is
opened.
2. Open air filter cover by pushing button
(see illustration). Rem ove air filter.
NOTE: To avoid creating a fire hazard or
producingharmful evaporative emissions,do
not clean filter in gasoline or other flammable
solvent.
3. Wash the filter in soap and water.
4. Allo w filter to dry .
5. Replace air filter and close cover.
Air Filter Cover
Air Filter
Button