Filter
Top Products
-- 4 --
SAFETY RULES
STARTING
TO STOP THE ENGINE:
D
The
ON/STOP
switchisused tostop the en-
gine. The switch stays in the ON position.
To stop engine, press and hold the switch
in the STOP position until the engine
comes to a complete stop.
BEFORE STARTING THE ENGINE:
D
Fuel the engine. Move at least 10 feet (3
meters) away from the fueling site.
D
Hold the unit in the starting position as
shown. Make sure the blower end is di-
rected away from people, animals, glass,
and solid objects.
STARTING
POSITION
WARNING:
When starting engine,
hold the unit as illustrated. Do not set unit on
any surface except a clean, hard area when
starting engine or while engine is running.
Debris s uch as gravel, sand, dust, grass,
etc. could be picked up by the air intake and
thrown out through the discharge opening,
damaging the unit or property, orcausing se-
rious injury to bystanders or the operator.
Throttle
Trigger
Switch
Choke Lever
(shown in
HALF CHOKE
position)
Throttle
Lock
STARTING A COLD ENGINE (or a
warm engine after running out of
fuel)
D
Move choke to FULL CHOKE position.
D
Activate the throttle lock as f ollows:
D
squeeze and hold throttle trigger;
D
press and hol d throttle lock, then
D
release the throttle trigger
D
Pull starter rope handle sharply until en-
gine attempts to run, but NOMORE THAN
6 PULLS.
NOTE:
:
The engine maysound as i fit is try-
ing to start before the 6th pull. This sound
may behard to hear. If so, go to the next step
immediately.
D
Move choke to HALF CHOKE position.
D
Pull starter rope handle sharply until en-
gine runs, but no more than 6 pulls.
NOTE:
If engine has not started after 6
pulls, repeat all of the above steps.
D
Allow engine to run for 10 to 15 seconds,
then movechoke toOFF CHOKE position.
D
Squeeze and release the throttle trigger to
release the throttle lock.
NOTE:
If engine di es with choke at OFF
CHOKE position, move the choke to the
HALF CHOKE position and pul l the starter
rope handle 5 more times. If engine does not
start and operate properly, refer to CARBU-
RETOR ADJUSTMENTS.
D
To stop engine, press and hold switch in
the OFF position.
STARTING A WARM ENGINE:
D
Move choke to HALF CHOKE position.
D
Activate the throttle lock.
D
Pull starter rope handle sharply until en-
gine runs, but no more than 6 pulls.
D
Move choke to OFF CHOKE position.
Then, squeeze and release the throttle
trigger to release the throttle lock.
NOTE:
If engine does not run after 5pulls, it
is probably flooded. Wait a few minutes and
repeat procedure with choke at OFF
CHOKE.
D
To stop engine, press and hold switch in
the OFF position.
DIFFICULT STARTING (or starting a
flooded engine)
Flooded engines can be started by placing
choke leverinthe OFFCHOKE position. Ac-
tivate the throttle lock, then, pull rope until en-
gine starts. After the engine starts, squeeze
and release the throttle trigger to release the
throttle lockand allow engine to idle. Starting
could require pulling the starter rope handle
many times depending on how badly unit is
flooded. If unit still doesn’t start, refer to the
TROUBLESHOOTING TABLE or call
1--800--554--6723.
SAFETY RULES
SERVICE
We recommend all service and adjustments
not listed in this manual be performed by an
Authorized Service Dealer.
CARBURETOR ADJUSTMENTS
Your carburetor is equipped with limiter
caps. Carburetor adj ustment is a compli-
cated task. We recommend that you take
your unit to an Authorized Service Dealer.
Damage will occur ifyou turnthe needles be-
yond the limiter stops.
SPARK PLUG
Replace spark plug yearlyusing aChampion
RCJ-8Y spark plug. Spark plug gap is .025”.
IGNITION TIMING
Ignition timing is fixed, nonadjustable.