Filter
Top Products
3
S
Empty fuel tank before storing ortransport-
ing the unit. Useup fuel left inthecarburetor
by starting engine and letting it run until it
stops.
S
Store unit and fuel in anarea where fuel va-
pors cannot reach sparks or open flames
from water heaters, electric motors or
switches, furnaces, etc.
S
Store unit so l ine limiter cannot accidentally
cause injury. Unit can be hung by the tube.
S
Store the unit out of the reach of children
If situations occur which are not covered in
this manual, use care and good judgment. If
you need assistance, call 1-800-554-6723.
SPECIAL NOTICE:
This unit is not
equipped with a temperature l imiting muffler
and spark arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines to
be equipped with a spark arrestor screen. If
you operate in a locale where such regula-
tions exist, you are legally responsible for
installing and maintaining the operating con-
dition of these parts. Failure todo soisaviola-
tion of the law. If a spark arrestor is required
in your area, contact your Authorized Service
Dealer for the proper kit.
SPECIAL NOTICE:
Exposure to vibra-
tions through prolonged use of gasoline pow-
ered hand tools could cause blood vessel or
nerve damage in the fingers, hands, and
joints of people prone to circulation disorders
or abnormal swellings. Prolonged use in cold
weather hasbeen linked toblood vessel dam-
age in otherwise healthy people. If symptoms
occur such as numbness, pain, loss of
strength, change in skin color or texture, or
loss of feeling in the fingers, hands, or joints,
discontinue the use ofthis tool andseekmed-
ical attention. An anti-vibration system does
not guarantee the avoidance of these prob-
lems. Users who operate power tools o n a
continual and regular basis m ust monitor
closely their physical condition and the condi-
tion of this tool.
ASSEMBLY
WARNING:
Make sureunit is properly as-
sembled and all fasteners are secure.
Groove
ATTACHING THE HANDLE
S
Assemble the handle to the unit as shown;
make surebottom of handle i sseated inthe
groove in the trigger housing.
NOTE:
Adjustment knob must be as-
sembled on the side of unit opposite opera-
tor’s position.
S
Pivot handle to a comfortable position.
Tighten handle securely.
ATTACHING THE SHIELD
WARNING:
The shield helps to protect
the operator and others from thrown objects,
and is equipped with a line limiter blade which
cuts excess line. The blade (on underside of
shield) is sharp and can cut you.
S
Remove wing nut from shield.
S
Insert bracket into slot as shown.
S
Pivot shield until bolt passes through hole
in bracket.
S
Securely tighten wing nut onto bolt.
Slot
Shield
Wing
Nut
Bracket
FUEL YOUR UNIT
This engine is certified to operate on un-
leaded gasoline. Gasoline must be mixed
with a good quality 2-cycle air-cooled engine
oil designed to be mixed at a ratio of 40:1.
Poulan/Weed Eater brand oil is recom-
mended. (A 40:1 ratio is obtained by mixing
3.2 ounces of oil with 1 gallon of unleaded
gasoline). When mixing fuel follow the
instructions printed on the container. Always
read and follow the safety rules under
FUEL
SAFETY.
STARTING
Starting Position
HOW TO STOP YOUR UNIT
Push and hold the engine stop switch in the
STOP
or
OFF
position until the unit has fully
stopped.