Weed Eater 2695 Blower User Manual


 
7
Direct air flow by directing the blower tube/
nozzle down o r to one side. Alw ays work
away from solid objects such as w alks,
large stones, vehicles, and fences.
Clean corners by starting in corners and
moving outward. This will help prevent an
accumulation of debris which could fly into
your face.
Be careful when w orking near plants. The
force of the air could damage tender plants.
USING YOUR UNIT AS A VACUUM
WARNING:
Do not vacuum
stones, gravel, metal, broken glass, etc.,
to avoid severe damage to the impeller.
Toavoid the possibility of electrical shock,
do not attempt to vacuum water or other
liquids.
Use your unit as a vacuum to pick up dry
material such as leaves, grass, small
twigs, and bits of paper.
D
For best results during vacuum use,op-
erate your unit at high speed.
D
Move slowly back and forth over the
material as you vacuum. Avoid forcing
the unit into a pile of debris as this can
clog the unit.
D
Keep the vacuum tube about an inch
above the ground for best results.
WARNING:
If the unit becomes
clogged, stop the unit and unplug the ex-
tension cord. Wait until the impeller has
completely stopped turning, then remove
the vacuum tubes. Carefully reach into
the vacuum opening and clear out the
clogged debris.
MAINTENANCE
WARNING:
Disconnect power
source before performing maintenance.
GENERAL RECOMMENDATIONS
The w arranty on this unit does not cover
items that have been subjected to operator
abuse or negligence. To receive full value
from the warranty, the operator must main-
tain unit as instructed in this manual. Vari-
ous adjustments will need to be made peri-
odically to properly maintain your unit.
BEFORE EACH USE
CHECK FOR LOOSE FASTENERS
AND PARTS
S
Inlet C over
S
Blower Tube
S
Vacuum T ubes
S
Co llection Bag
CHECK FOR DAMAGED OR
WORN PARTS
Contact an authorized service dealer for
replacement of damaged or worn parts.
S
ON/OFF
Switch -- Ensure switch functions
properly by moving the switch to the
OFF
position. Make sure motor stops; then re-
start m otor and continue.
S
Inlet C over -- Discontinue use of unit if in-
let cover fails to latch properly or if it is
damaged in any way.
AFTER EACH USE
INSPECT AND CLEAN UNIT & LABELS
Stop unit and unplug extension cord.
S
After each use, inspect complete unit for
loose o r damaged parts. Clean the unit
using a damp cloth with a m ild detergent.
S
Wipe off unit with a clean dry cloth.
CLEAN COLLECTION BAG
IMPORTANT:
THE COLLECTION BAG
MUST BE PROPERLY EMPTIED.
D
You must properly empty and maintain
the collection bag to avoid deterioration
and obstruction of air flow.
D
Remove the collection bag from the unit
and empty after each use. Do not store
bag without emptying the bag of all con-
tents (grass, leaves, e tc.).
D
Wash the bag once a year. Remove the
bag from the blower and turn the bag in-
side out. W ash the bag w ith a water hose.
Allow the bag to hang and dry completely
before you reuse the bag.
SERVICE
HOW TO REMOVE AN OBJECT
FROM THE AIR INTAKE
WARNING:
Stop the unit and dis-
connect from the power source before
opening the inlet cover. The motor must
be stopped and the impeller blades no
longer turning to avoid serious injury from
the rotating blades.
S
While holding the inlet cover open, re-
move the vacuum tubes. The inlet cov-
er must be held open through all re-
maining steps.
S
Carefully reach into the vacuum open-
ing and clear out the air intake area.
Clear all debris from impeller.
S
Inspect the impeller for cracks. If
cracked or damaged, do not use the
unit. Have parts replaced by your au-
thorized service dealer. Do not attempt
to replace them yourself.