Filter
Top Products
9
TROUBLE CAUSE REMEDY
Trimmer head
stops under a
load or does not
turn when switch
is pressed.
1. Allow tip of line to do the cutting.
2. Contact your authorized service dealer.
3. Check Breaker Box.
4. Remove debris.
Line does not
advance or
breaks while
cutting.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only 0.065 in. (1.65 mm) dia. line.
4. Remove spool cap and pull 4 inches
(10 cm) of line out of head.
5. Clean unit.
Line welds onto
spool.
1. Use only 0.065 in. (1.65 mm) dia. line.
2. Replace with correct spool.
3. Cut with tip of line fully extended.
Line releases
continuously.
1. Check line routing.
2. Replace spool.
Line pulls back
into head.
1. Too little line outside
of head.
2. Line size incorrect.
1. Remove spool cap and pull 4 inches
(10 cm) of line outside of head.
2. Use only 0.065 in. (1.65 mm) dia. line.
TROUBLESHOOTING TABLE
1. Line improperly
routed in head.
2. Spool damaged.
1. Line size is incorrect.
2. Incorrect spool.
3. Line is being crowded
against material being
cut.
1. Line improperly routed
in head.
2. Line improperly
wound into spool.
3. Incorrect line size
4. Not enough line
outside of head.
5. Dirt buildup on unit.
1. Crowding trimmer line
against material being
cut.
2. Electrical failure.
3. Thrown circuit breaker.
4. Debris stopping head.
Line usage i
s
excessive.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully extended.
4. Replace spool.
1. Line improperly routed
in head.
2. Line size is incorrect.
3. Crowding line against
material being cut.
4. Spool worn or damaged.
WARNING: Alwaysstopunitanddisconnectfromthepowersourcebeforeperforming
allofthe recommendedremedies below exceptremediesthat require unit tobe operating.
USER REPLACEABLE SERVICE PARTS
Spool with 0.065″ Trimmer Line
574496301
952711920
Spool cap
574492201
Bolt
574471601
eldnaHtsissA
574473201M6x1,egairraCtloB
574473101Knob
574491401
574491601
ylbmessAdleihS
ediuGegdE
REPLACEMENT PART PART NUMBER
STORAGE
WARNING: Perform the following
steps after each use.
• Stop the unit and disconnect the power
source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter blade can-
not cause injury.
• Store unit and extension cord indoors in a
high, dry place out of the reach of children.
Store unit unplugged.
• Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.