Filter
Top Products
-6-
Assembling Your Telescope (continued)
2. Connect each leg and the mount base using long
screws and wing nuts (see fig. 2a), but not tighten.
3. Stretch out the tripod legs so that you can put the
accessory dish on it, connecting them with short screws
and wing nuts (see fig. 3) . Tighten the wing nuts of the
tripod legs.
4. Connect the pitching shaft to the main tube using the
pitching shaft screw (see fig. 2b) .
5. Loosen the left and right blocks on the main tube, and
then connect the main tube to the main mount. Tighten
the right and left blocks (see fig. 2c) and tighten the
pitching clamp handle screw (see fig. 2d ).