Filter
Top Products
SPECIAL FEATURES:
AUTOMATIC FILTRATION:
This spa is set to filter your water anytime the Jet/Pump is running.
AUTO HEAT:
Heat is generated and transferred into the water by capturing the heat emitting
from the motor. This economical transference of heat will continue until the desired
temperature is achieved. The spa control system will monitor the water temperature
twenty-four hours a day and will cycle the jet/pump on and off whenever the need for
heat is called for.
SPA SIDE RESET:
This electronic system is equipped with two levels of resets. Both resets are performed
on the top side control.
1st. Reset: The first reset is to clear any glitches that have corrupted the systems
operation by faulty electrical systems, lightning storms, etc.
Depress the
Down arrow for 5 seconds and release. This will clear and reload your spec-
ified heater setting without the need to reprogram the system.
2nd. Reset : We like to call it a Reboot. This reset will clear current programming and
reload the system with factory defaults.
Depress the
Up Arrow button for 5 seconds and release.
Note: If the 2nd. Reset was completed correctly, the time on the display reverts to
12:00 PM. At this time you will need to reprogram the system with your settings.
DIRECTIONAL & ROTATIONAL MASSAGE JETS
The water flow direction is adjustable by rotating the directional jet nozzle.The amount
of pressure can be adjusted by rotating the outer rim of the jet(s)
:clockwise for minimum
pressure, and counter clockwise for maximum pressure. Pressure may also be varied by
the use of the air control.
AIR CONTROL
The air control is used to introduce air into the water jet stream. This control allows the
user to increase (open) jet pressure or decrease (close) jet pressure as desired.
—8 —