Filter
Top Products
Cutting Deck Removal
To remove the cutting deck, proceed as follows:
position and engage the parking brake.
2. Lower the deck by moving the deck lift lever into the
bottom notch on the right fender.
3.
Remove the belt guard and belt as follows Refer to Figure
a. Remove the hex screw.
b. Pull the belt keeper rod to the right and down to
remove.
c.
Belt Keeper
Rod
Figure 7-1
NOTE: If there is too much tension on the belt for it to be
a ⁄ drive ratchet wrench (set to loosen) into the square
hole found in the left-hand deck idler bracket and pivot it
See Figure 7-2.
Deck Idler
Bracket
Insert Ratchet
Here
Figure 7-2
WARNING! Avoid pinching injuries. Never place
your fingers on the idler spring or between the belt
and a pulley while removing the belt.
5. Looking at the cutting deck from the left side of the tractor,
locate the deck support pin on the rear left side of the
deck.
Se rvice
7
24