Filter
Top Products
Recoil Starter
CAUTION: Do not pull the starter handle while the
engine running.
WARNING! To avoid unsupervised engine
operation, never leave the engine unattended while
running. Turn the engine off after use and remove
ignition key
engine cannot start unless the key is inserted into the
ignition switch.
Move the throttle control to the FAST (rabbit) position.2.
3.
cover the vent hole when pushing. If the engine is warm,
push the primer only once. Always cover the vent hole
when pushing. Cool weather may require priming to be
repeated.
5.
resist, then pull quickly and forcefully to overcome the
compression. Do not release the handle and allow it to
If required, repeat this step.
As the engine warms, slowly rotate the choke control to the
run with the choke at half-choke position for a short period
Stopping the Engine
WARNING! To avoid unsupervised engine
operation, never leave the machine unattended
with the engine running. Turn the engine off after
use and remove ignition key
Run the engine for a few minutes before stopping to help dry off
any moisture on the engine.
Remove the ignition key. Removing the key will reduce the 2.
possibility of unauthorized starting of the engine while the
equipment is not in use. Keep the key in a safe place. The
engine cannot start without the ignition key.
Wipe any moisture away from the controls on the engine.3.
To Engage Augers
To engage the augers and start throwing snow, squeeze
the auger control against the handle. Release to stop the
augers.
Engaging the Drive
Lift up slightly on the handle to allow the rubber paddles on the
auger to contact the pavement and propel the snow thrower
off the ground and stop the forward motion.
NOTE:
in premature wear on the rubber auger blades which are
not be covered by the warranty.
13se c t i O n 5 — Op e r a t i O n