Filter
Top Products
fshotorrunning. Allow engfne to cool at least two
minutes before refueling.
"10. Never over fill fuel tank. Ff]l tank to no more than ½
fnch below bottom of ffller neck to provfde space for
fuel expansion.
"11. Replace gasolfne cap and tighten securely.
"12. If gasoline is spilled, wipe ft off the engine and
equfpment. Move unit to another area. Waft 5
minutes before starting the engine.
"13. Never store the machine or fuel container fnsfde
where there fs an open flame, spark or pflot lfght as
on a water heater, space heater, furnace, clothes
dryer or other gas appliances.
"14.To reduce fire hazard, keep mower tree of grass,
leaves, or other debris build-up. Clean up oil or fuel
spillage and remove any fuel soaked debris.
"15.Allow a mower to cool at least 5 minutes before
storing.
GeneralService:
"1. Never run an engine indoors or in a poorly
ventilated area. Engine exhaust contains carbon
monoxide, an odorless and dead]y gas.
2. Before cleaning, repairing, or inspecting, make
certain the blade and al] moving parts have
stopped. Disconnect the spark plug wire and
ground against the engine to prevent unintended
starting.
3. Check the blade and engine mounting bolts at
frequent intervals for proper tightness. Also,
visually inspect blade for damage (e.g., bent,
cracked, worn) Replace blade with the original
equipment manufacture's (O.E.M.) blade only,
listed in this manual. "Use of parts which do not
meet the originalequipment specifications may
lead to improper performance and compromise
safety!"
4. Mower blades are sharp and can cut. Wrap the
blade or wear gloves, and use extra caution when
servicing them.
5. Keep al] nuts, bolts, and screws tight to be sure the
equipment is in safe working condition.
6. Never tamper with safety devices. Check their
proper operation regularly.
7. After striking a foreign object, stop the engine,
disconnect the spark plug wire and ground against
the engine. Thoroughly inspect the mower for any
damage. Repair the damage before starting and
operating the mower.
8. Never attempt to make a wheel or cutting height
adjustment while the engine is running.
9. Grass catcher components, discharge cover, and
trail shield are subiect to wear and damage which
could expose moving parts or allow objects to be
thrown. For safety protection, frequently check
components and replace immediately with original
equipment manufacturer's (O.E.M.) pads only,
listed inthis manual. "Use of parts which do not
meet the originalequipment specifications may
lead to improper performance and compromise
safety!"
"10. Do not change the engine governor setting or
overspeed the engine. The governor controls the
maximum safe operating speed of the engine.
"11. Maintain or replace safety and instruction labels, as
necessary.
"12. Observe proper disposal laws and regulations.
Improper disposal of fluids and materials can harm
the envfronment.
YourResponsibility
• Restrict the use of this power machine to persons who read, understand and follow the warnings and
instructions in this manual and on the machine.
WARNING,