Filter
Top Products
Chute Assembly
The distance snow is thrown can be adjusted by changing the
angle of the chute assembly. To do so:
Stop the engine by removing the ignition key and loosen
the plastic knob found on the left side of the chute
assembly.
2.
Auger Control
WARNING!
carefully read and follow all instructions below.
is operating safely and properly.
Check the adjustment of the auger control as follows:
When the auger control is released and in the disengaged 3.
In a well-ventilated area, start the snow thrower engine.
throttle is set in the FAST position.
While standing in the operator’s position (behind the snow 5.
thrower), engage the auger.
Allow the auger to remain engaged for approximately ten
several times.
With the throttle control in the FAST (rabbit) position and 7.
the front of the machine.
Confirm that the auger has completely stopped rotating 8.
signs of rotating, immediately return to the operator’s
position and shut off the engine. Wait for ALL moving parts
to stop before re-adjusting the auger control.
To readjust the control cable, loosen the upper hex nut on
downward to increase cable tension).
Retighten the upper hex nut.
been achieved.
Figure 3-10
Figure 3-11
Figure 3-9
10 se c t i O n 3— as s e M b l y & se t-up