Filter
Top Products
7
Figure 5
Tire Pressure (Pneumatic Tires)
The tires are overinflated for shipping purposes.
• Check tire pressure. Maintain pressure between 10
and 14 psi.
NOTE: If the tire pressure is not equal in all tires, the
unit may pull to one side or the other.
SECTION 3: KNOWING YOUR SNOW THROWER
• Compare the figure below and description of controls in this section with your equipment before starting unit.
Figure 6
Auger
Control
Z-End
Jam Nut
Auger
Control Cable
WARNING: Maximum tire pressure under
any circumstance is 30 psi. Equal tire pressure
should be maintained at all times. Excessive
pressure (over 30 psi) when seating beads
may cause tire/rim assembly to burst with force
sufficient to cause serious injury.
WARNING: Be familiar with all the controls on the snow thrower and their proper operation. Know how to
stop the machine and disengage them quickly.
Chute Crank
Auger Drive Control
Traction Control/Auger Control Lock
Discharge Chute
Chute Tilt Control
Shift Lever
Chute Clean-Out
Gas Cap
Oil Fill
Head Light
Heated Grip
Skid Shoe
Augers
Wheel Steering Control
Steering
Control
Tool
Heated Grip Switch