Troy-Bilt 80 Lawn Mower User Manual


 
11
SECTION 6: MAINTAINING YOUR LAWN MOWER
General Recommendations
Always observe safety rules when performing any maintenance.
The warranty on this lawn mower does not cover items that have been subjected to operator abuse or
negligence. To receive full value from the warranty, operator must maintain the lawn mower as instructed here.
Changing of engine-governed speed will void engine warranty.
All adjustments should be checked at least once each season.
Periodically check all fasteners and make sure these are tight.
Lubrication
Blade Control Handle
Lubricate the pivot points on the blade control
handle at least once a season with light oil.
The blade control must operate freely in both
directions. See Figure 10.
Wheels
If your mower is equipped with ball bearing
wheels, lubricate at least once a season with
a light oil, all other types require no
lubrication. However, if the wheels are
removed for any reason, lubricate the surface
of the axle bolt and the inner surface of the
wheel with light automotive oil.
Chute Deflector
Lubricate the torsion spring and pivot point
periodically with light oil to prevent rust. See
Figure 10.
Engine
Follow the accompanying engine manual for
lubrication schedule and instruction.
Cleaning Mower
The underside of the mower deck should be cleaned after each use to prevent a buildup of grass clippings,
leaves, dirt or other matter. Follow the steps below for this job.
NOTE: We do not recommend the use of pressure washers or garden hose to clean your unit. These may cause
damage to electric components, spindles, pulleys, bearings, or the engine. The use of water will result in shortened
life and reduce serviceability.
1. Disconnect spark plug wire. Drain gasoline from the lawn mower, or place a piece of plastic under the gas cap.
2. Tip the mower so that it rests on the housing. Keep the side with the air cleaner facing up. Hold the mower firmly.
3. Scrape and clean the underside of the deck with a suitable tool. Do not spray with water.
4. Put the mower back on its wheels on the ground. If you had put plastic under the gas cap earlier, make sure to
remove it now.
WARNING: Always stop engine, disconnect spark plug, and ground against engine before cleaning,
lubricating or doing any kind of maintenance on your machine.
WARNING: Never tip the mower more than 90 degrees in any directions and do not leave the mower
tipped for any length of time. Oil can drain into the upper part of the engine causing a starting problem.
Figure 10
Lubricate these
points
Lubricate these
points