Filter
Top Products
13
Yard waste such as leaves and pine needles can be
vacuumed up through the nozzle for shredding. After
material has been shredded by the flail blades on the
impeller assembly, it will be discharged into catcher bag
or through blower chute. Do not attempt to shred or chip
any material other than vegetation found in a normal yard
(i.e. branches, leaves, twigs, etc.) Avoid fibrous plants
such as tomato vines until they are thoroughly dried out.
Materials such as stalks or heavy branches up to 1-1/2” in
diameter may be fed into the chipper chute.
WARNING: Do not attempt to shred,
chip, or vacuum any material larger
than specified on the machine or in this
manual. Personal injury or damage to
the machine could result.
IMPORTANT: The flail screen is located inside the
housing in the discharge area. If the flail screen becomes
clogged, remove and clean as instructed in the Mainte-
nance section on page 16. For best performance, it is
also important to keep the chipper blade sharp.
WARNING: Do not at any time make
any adjustments without first stopping
engine and disconnecting spark plug
wire.
Using The Hose Assembly
1. Place nozzle/hose vac handle in the bottom position
on the nozzle to redirect vacuum to the hose assem-
bly. See Figure 13.
2. The spring loaded pin must be in the second hole of
the hose adapter to operate the hose assembly.
3. Unhook the hose from upper handle bracket and
grasp the hose handle to guide while vacuuming yard
waste such as leaves or pine needles in hard to reach
places.
Figure 13
4
Operating
Your Yard
Vacuum
WARNING
Do not attempt
to shred, chip, or
vacuum any material
larger than specified
on the machine or in
this manual. Personal
injury or damage to
the machine could
result.
Do not at any time
make any adjust-
ments without first
stopping engine and
disconnecting spark
plug wire.