Toro INF35-6 Sprinkler User Manual


 
15
To Reinstall Main Valve
Use the valve insertion tool. ere are two sizes of the tool depending on the size of the sprinkler inlet.
118-1843 is the 1.5” (40 mm) valve insertion tool
118-1844 is the 1” (25 mm) valve insertion tool
1
Load snap ring onto insertion tool.
Trigger is in “down” position.
2
“Step” side of ring faces up.
Ring “hooks” are hooked
around insertion tool prongs.
3
Align valve communication port
with notch on insertion tool.
Load valve assembly onto tool.
4
Insert valve assembly.
5
Align the tool handle, the snap ring,
and the valve with the notch in body.
6
Push tool down completely then pull
up on “trigger” to release the snap
ring.
7
Remove tool.
Replace riser assembly.
(See page 13 for full procedure.)
8
e snap ring will “snap!” into groove when properly installed. Remove insertion tool and check snap ring to conrm
that it is fully seated in groove.