Filter
Top Products
7
3329–341
2. Remove the cap
and spool.
Note: If the spring falls
off, install it before
installing the spool.
3. Thoroughly clean
the cutting head and cap
and inspect them for any
damaged or worn parts.
mĆ6304
Rewinding the Spool
Note: If you are replacing the spool with a new,
pre-wound spool, discard the empty spool and skip
this section.
1. Remove any cutting line left on the spool.
2. Hook one end of line
all the way into the slot
on the spool, allowing
no more than 1/8 inch
(3 mm) to protrude.
3. Wind the line in the direction of the arrow on the
spool, in level rows, between the spool flanges.
Note: The trimmer will not function correctly if you
wind the line in the wrong direction, the end of the line
protrudes more than 1/8 inch (3 mm), or you wind
more than 30 ft of line on the spool.
Installing the Spool
Caution
If you do not fully install the spool and cap, the
trimmer could throw them during operation,
causing injury to you or bystanders.
Ensure that you fully install the spool and cap.
1. Holding the line and
spool, insert the spool
into the cutting head and
the line into the eyelet.
m-6298
2. Holding the line and
spool, place the cap
over the spool.
m-6297
3. Twist the cap on
securely clockwise.
m-630
3
Maintenance
After each use of the trimmer, complete the following
procedures:
• Wipe the trimmer clean with a damp cloth. Do
not hose the trimmer down or submerse it in
water.
• Wipe or scrape clean the cutter head and spool
area any time there is an accumulation of dirt or
cuttings.
• Check and tighten all fasteners. If any part is
damaged or lost, repair or replace it.
• Brush debris away
from air intake
vents.
Important: Keep the air intake vents free of grass
and debris to prevent the motor from overheating.
Storage
For idle periods of more than a month, disconnect the
charger from the wall outlet and trimmer after the
trimmer is fully charged. Do not store the trimmer with
the charger plugged in. Storing trimmer in a warm
area will decrease life of battery. If the trimmer must
be stored in a warm area, charge battery for 24 hours
every 2–3 months when not in use.