Filter
Top Products
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description
Qty.
Use
1.
No parts required
–
Unfold the handle.
Screws
3
2.
Chute assembly
1
Install the discharge chute.
1. Unfolding the Handle
Procedure
1. Loosen the lower handle knobs, pull out the handle
bolts until you can move the handle freely, and rotate
the handle to the operating position (Figure 3).
Figure 3
1. “U”-shaped handle lock (2)
2. Handle knobs
2. Insert the end of the “U”-shaped handle lock into
the open hole in the handle and tighten the handle
knobs until they are snug (Figure 4).
Figure 4
Important: Ensure that you do not pinch or
kink the control cable or the Quick Shoot™
cables (Figure 5).
Figure 5
1. Control cable 2. Quick Shoot™ cables
5