Filter
Top Products
Ifnotalreadyattached,slipthecablesthatrunfrom
thehandlepaneltothechuteassemblyintothe
cableguidelocatedontopoftheengine.See
Figure3.
Cable Cable
Guide
J
_ute
Figure 3
If not already attached, unwrap the headlight wire
which is attached to the headlight, beneath the
handle panel. Wind the headlight wire around the
lower right handle until excess slack is removed.
See Figure 4.
• Plug the wire from the headlight into the alternator
lead coming from the right side of the engine
underneath the fuel tank.
Alternator Lead
Lar_
NOTE: Wheels are omitted from illustration for clarity.
Figure 4
Clean-0utT001
• This tool, along with the electric cord, is fastened
with a cable tie to the rear of the auger housing for
shipping purposes. Cut the cable tie and remove
the electric cord before operating the snow thrower.
SECTION3: KNOWYOURSNOWTHROWER
Drive Control / _Shift Lever.,
Aug _ _Chute Tilt
_Control
Switchf
Headlic
Chute
_T Heated Gript
AaUcgkerst_r_ _ OntrOI
Control
Chute Directional
Control
Primer
Choke_@_
K
Ignition Key
Thr )ttle
t Model 1028 Control
tt Model 1130 equipped with one (1)
Electric
Starter
_RI_ Butt°n
Switch
ox
ecoil
Y Starter
......... Handle
i ji
Fuel Shut-Off Valve
*If Equipped
Figure 5
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
DriveControl/ AugerControlLock
The drive control is located on the right handle.
Squeeze the drive control to engage the wheel drive.
Release to stop. See Figure 5.