Filter
Top Products
MAINTENANCE
Maintenance Section 5-10
MAINTENANCE
© 2004 Alamo Group Inc.
TWR-180/TWR-120 12/04
Decal # 226-085 Location: Splitter Shield
Grease Schedule
Grease should meet the following recommendations:
-SAE Multi-purpose grease
-SAE Multi-purpose grease containing 3 to 5 percent molybdenum
disulfide
Use SAE (NLGI) #2
IMPORTANT: Before attaching the driveline, clean and grease the tractor PTO and the Implement
shaft.
Universal Joint Assemblies.
-Type of Grease: A good quality NLGI #2 EP grease, lithium soap base should be used to grease
the needle bearings in cross journals, shield bearings, telescoping members and CV
centeringmechanism. For heavy duty applications a compatible grease with 3 to 5% molybdenum
disulfide additive may be used.
-Cross Journals: Every 8 hours.
Lubricate until grease purges from underneath all four needle bearing caps.
-Shield Retaining Bearings: Every 8 hours.
The shield bearings are greased by a fitting molded into the shielding bell. Three pumps are
required.
IMPORTANT: Check that the driveline shielding is not damaged and rotates freely on the driveline.
-Constant Velocity Body: Every 4 hours.
The housing for the CV body serves as a reservoir for the lubrication of the centering mechanism.
Approximately 30 pumps are required every 4 hours.