Filter
Top Products
ASSEMBLY
Assembly Section 2-4
POLYCARBONATE SAFETY WINDOW
NOTE: In most cases this should be done before mounting the main frame. Carefully
remove the existing right rear cab window, to be replaced with the matching
polycarbonate window provided.
Clean all of the surfaces around the window opening, once the rear window is
removed. Peel back the protective paper from the area around the window that will
contact the window frame. Apply a bead of urethane window adhesive, supplied in
kit, around the window opening. Carefully position the new window into position. Fill
the remainder of the gap around the window with the adhesive, to finish. Be sure to
follow the instructions on the adhesive label when installing window.
Next, install the upper and lower door hinges along with the existing cab door
hinges. To do this, you will remove the existing hinge hardware and install the
existing hardware on the polycarbonate as shown in the Parts Section. Set the safety
screen assembly on the hinges and attach the door to the tractor frame. Install the
brackets with the hardware shown in the Parts Section. Assemble the rod with the
vibration isolator and nuts and attach them to the brackets. Adjust the vibration
isolator on the upper and lower brackets to achieve a good fit with the window.
Installing a boom mower requires that all right side windows be replaced or shielded
by a lexan safety window.
(ASM-JD-0061)
MAIN FRAME INSTALLATION
With an overhead hoist and / or jack-stands, raise one side of the frame up to the correctly
matching mounting holes. Install capscrews and all other hardware as shown in main frame
parts section to secure the sides of the main frame to the tractor casting, DO NOT tighten at this
time. Remove the capscrews one at a time and apply a thread locking agent. Reinsert the
capscrews and tighten / torque to values noted in the torque chart located in the maintenance
section of this manual.
(ASM-C-0003)