Filter
Top Products
181-1275-14 4-Cycle • Snow King Engine Page 19
5. Place approved recyclable oil container under oil drain
plug, if present. See Figure 41 on page 18. Afterward,
continue reading instructions below.
6. Remove oil drain plug, if present.
7. Tip engine to position the oil flow, so it will drain from
the lowest point on the engine (see equipment manu-
facturer’s instructions).
8. Drain oil into an approved recyclable oil container.
NOTE
Used oil must be disposed of at a proper collection center.
9. Install oil drain plug and tighten securely.
10. Clean area around oil drain plug. See Figure 41 on
page 18. Afterward, continue reading instructions
below.
11. Remove oil fill cap/dipstick. See Figure 42.
12. Fill with recommended oil. See Figure 43. See "III. Oil
and Fuel Specifications" instructions on page 4. See
Table 1 on page 4. Afterward, continue reading instruc-
tions below.
NOTES
DO NOT overfill oil filler. Doing so may result in oil carry-
over to the equipment and cause malfunction or damage.
DO NOT allow oil level to fall below the “ADD” mark on oil
fill cap/dipstick. Doing so may result in equipment
malfunction or damage.
Contact your Authorized Tecumseh Servicing Dealer for
Tecumseh Oil.
13. Wipe away any spilled oil.
14. Install oil fill cap/dipstick. Tighten securely.
See Figure 42.
15. Carefully disconnect spark plug wire from grounding
post, if provided. See Figures 38 and 39 on page 18.
See "G. Avoid Accidental Starts" instructions on page
2. Afterward, continue reading instructions below.
16. Carefully re-connect spark plug wire to spark plug.
See Figures 38 and 39 on page 18.
Figure 42. Oil Fill Cap/Dipstick Locations
Figure 43. Engine Oil Level
OH318SA/OH358SA OH195SA/OH195SP
LH318SA/LH358SALH195SA/LH195SP
FULL
ADD
OK
Fill Between
“FULL” and “ADD”
Marks
File was named: 181-1275-14MY060105x.fm