Filter
Top Products
10
Dimmer Troubleshooting
The front display can be dimmed to suit your preferred
environment. There are two levels and an “off” setting.
Press the A button for more than 2 seconds to switch
the dimmer mode.
LEd OFF 1:
All the illuminations are turned off except the MASTER
button indicator (Xtal, Rb, Ext).
LEd OFF 2:
All the illuminations are turned off.
LEd ON:
Normal mode.
< Note that the OFF setting is memorized when the power is
turned off.
< In OFF mode, when you turn on the power or you operate
other buttons, the illuminations turn temporarily on, and after
the clock signal is stabilized, it turns off. (After the indicator
for the MASTER button stops blinking and lights steadily.)
In case you experience any problem with this unit, please take
the time to look through this chart and see if you can solve the
problem yourself before you call your dealer or a TEAC service
center.
No power
e
Check the connection to the AC power supply. Check and
make sure the AC source is not a switched outlet and that,
if it is, the switch is turned on. Make sure there is power to
the AC outlet by plugging in another item such as a lamp or
fan.
e
Turn on the POWER switch on the rear panel.
Not synchronized
e
Check to see if the current word clock output is supported
by the connected players. If necessary, select a word clock
frequency that is appropriate for the individual players.
There are occasions where the word clock available for
synchronization varies depending on the connection and
settings of the individual players. For details, consult the
manual for each player.
e
If you are using the PAL FILM mode, check to see whether
the connected player supports the PAL FILM frequency (-4%
of the standard frequency).
e
Check to see whether the sync outputs on the rear panel are
connected to the acceptable sync inputs of the individual
players.
Desired frequency not selectable with A, B, and C buttons
e
Select the proper fundamental frequency in FREQUENCY
MODE before operating the buttons.
Odd sound pitch
e
Do not use the PAL FILM mode for NTSC discs or PAL discs
other than film source discs.
If normal operation cannot be recovered, unplug the
power cord from the outlet and plug it in again. This
resets the internal micro-computer which can be disturbed
during electrical storms, power interruptions, et cetera.
Maintenance
If the surface of the unit gets dirty, wipe with a soft cloth or
use diluted neutral cleaning liquid. Be sure to remove any
fluid completely. Do not use thinner, benzine or alcohol as
they may damage the surface of the unit.