Filter
Top Products
13
The remote Wind Gauge Sensor will transmit temperature and humidity
readings from one location. With the purchase of an additional 1 or 2
temperature/humidity sensors (not included), this Wireless Weather
System can monitor temperature and humidity readings in 1 or 2
additional locations. These remote sensors can be used to monitor
temperatures in a garage, basement, child's room, wine cellar, or any
other location within the transmission range. Please note these sensors
can only monitor temperature and humidity; wind-related readings can
only be measured by the one Wind Gauge Sensor that is
included in this package.
To purchase temperature/humidity remote sensors
(Taylor model 1438) visit www.partshelf.com.
To add a temperature/humidity Sensor (purchased separately):
1. Select a location for the remote sensor that is within the effective
transmission range.
2. Lift off the bracket stand, located on the back of the remote sensor, to
access the battery compartment cover.
3. Remove the 4 screws that secure the battery compartment cover and
then remove the cover.
4. Assign channel 2 or 3 to the remote sensor by setting the slide switch
inside the battery compartment. (Channel 1 is already assigned to the
Wind Gauge Sensor and should not be used by any other remote
sensors).
5. Insert 2 AAA alkaline batteries as indicated by the polarity symbols
marked inside the battery compartment.
6. Press and hold the “CHANNEL” button on the front of the receiver
unit to search for all remote sensor signals.
7. Press the Tx button in the remote battery compartment to send a
transmission to the receiver. The red LED Indicator light will flash
when a signal is transmitted. Remote unit temperature updates will
then be transmitted around every 35 seconds.
8. Replace the battery compartment cover, replace and tighten screws
and reattach the bracket stand.
9. When transmission connection is established, the respective
temperature and humidity of the selected remote channel will appear
on the home receiver's LCD screen. Note: If dashes are still
displayed for that channel on the receiver unit, press the Tx
button again to send another transmission.
10. Press the “CHANNEL” button to toggle between indoor and remote
sensor temperature/humidity displays.
Setting up Additional Temperature/Humidity Sensors (not included)