Filter
Top Products
Trouble-Shooting
Disconnected Signals
If the receiver unit does not receive a transmission from a remote chan-
nel for 1 hour,the display will show dashes.To correct this problem:
1. Check that the remote is properly positioned,within the appro-
priate transmission range.Transmissions are vastly affected by
building materials and where the receiver and remote units are
positioned.Try various set ups for the best results. Shorten the
distance between receiver and remote units when necessary.
2. Check to make sure the transmission path is clear of obstacles
and interference.
3. If new batteries are faulty on the initial installation, install fresh
batteries.If you did not notice the Low Battery icon warning and
the product performed correctly after initial set up,the batteries
have lost their charge.Replace batteries (see the Power Sources
section of this manual.)
4. Press the“Tx” button in the battery compartment of the remote
to send a transmission signal to the base unit.
5. Press and hold the“Channel” button on the back of the base unit.
This will clear the channel setting and the base unit will begin
searching for remote sensor transmissions.Press the“Tx” button
in the battery compartment of the remote to send a transmis-
sion signal to the base unit.
6. Press the “RESET” button in the remote sensor’s battery com-
partment to reset all sensor settings.
10