Filter
Top Products
www.tanaka-usa.com 11 custsvc@tanaka-ism.com
Owner’s Manual
TPS-2501,TPS-2510.TPS-250PN,TPS-270PN
Spark plug (Fig. 3-3)
The spark plug condition is influenced by:
• An incorrect carburetor setting.
• Wrong fuel mixture (too much oil in the gasoline)
• A dirty air filter.
• Hard running conditions (such as cold weather).
These factors cause deposits on the spark plug electrodes, which may result in malfunction and starting difficulties. If the engine
is low on power, difficult to start or runs poorly at idling speed, always check the spark plug first. If the spark plug is dirty, clean
it and check the electrode gap. Readjust if necessary. The correct gap is 0.6 mm (.024”). The spark plug should be replaced
after about 100 operation hours or earlier if the electrodes are badly eroded.
NOTE!
In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this machine was originally equipped
with resistor spark plug, use same type of spark plug for replacement.
Muffler (Fig. 3-4)
Remove the muffler and remove excess carbon from the exhaust port or muffler inlet every 100 hours of operation.
Cylinder (Engine cooling) (Fig. 3-5)
The engine is air cooled, and air must circulate freely around engine and over cooling fins on cylinder head to prevent
overheating.
Every 100 Operating hours, or once a year (more often if conditions require), clean fins and external surfaces of engine of
dust, dirt and oil deposits which can contribute to improper cooling.
NOTE!
Do not operate engine with engine shroud or muffler guard removed as this will cause overheating and engine damage.
Drain all fuel from fuel tank and pull fuel filter line from tank.
Pull filter element out of holder assembly. Replace filter if it
appears to be discolored or hardened from use. The filter
has a white, felt-like appearance when new.
Fuel Filter (Fig. 3-2B)
Chain oil filter (Fig. 3-2C)
Remove the oil filter and thoroughly wash it in solvent.