ALTERNATIVE STOPPING METHOD
•
Bring vehicle to complete stop, shut off engine, and set parking brake.
•
Disengage blade engage lever (6008).
•
Manually shut toggle and key switches to their “OFF” positions.
•
Always remember to remove keys to avoid irresponsible usage.
TRANSPORTING MOWER
•
Stop mower properly.
•
Place mower deck in its highest position.
•
If transporting unattached from tow vehicle, then remove spark plug wire and
place where it cannot contact the spark plug.
SUGGESTED MOWING PRACTICES
•
Operate mower engine at full throttle to assure the best cutting performance and
maximum material discharge.
•
Allow wet grass to dry. Clumps of wet grass will collect under the mowing deck.
•
Mowing should be started with tow vehicle in low gear and increased only as safe
mowing conditions permit. This speed should not exceed 5 MPH.
•
The average lawn should be cut to approximately 2.5” during the cool season and
to over 3” during the hot months.
•
For a healthier lawn and better aesthetics, your lawn should be mowed often and
after moderate growth.
•
When cutting high or dense grass areas go slowly. Some areas may need to be
mowed twice. The second cut should be at 90 degrees to the first, if possible.
•
Mowing thick or high grass.
Raise rear height crank handles to .5”-.75” above
the other two handles.
•
Creating a manicured lawn.
Lower rear height crank handle to .25”-.5” below
front of deck. This allows grass blades to be cut twice. It also continually cuts
clippings to produce a mulching effect.
GENERAL TROUBLE SHOOTING
•
The mower is not cutting level.
o
Level deck, making sure the side crank-handles are equal.
o
Check air pressure of all tires; make sure they are equal (about 15-18 psi).
o
Examine blades for damage, while mower engine is not running.
•
The engine will not start.
o
Disengage blades, turn toggle switch to “ON” position, check battery and
all other electrical connections, and inspect spark plug and wire.
o
Check for fuel in the engine.
•
Engine runs poorly.
o
See engine manual.
o
Check throttle adjuster.
o
Replace fuel, clean fuel filter and fuel line.
IF PROBLEMS PERSIST HAVE A QUALIFIED MECHANIC SERVICE THE
MOWER. NEVER ATTEMPT TO MAKE AN ADJUSTMENT THAT YOU ARE
NOT SURE IS CORRECT. DOING SO CAN CAUSE OTHER PROBLEMS.
9