Swisher POL 10550 Lawn Mower User Manual


 
STOP MOWING
Bring vehicle to a full stop.
Disengage clutch lever by moving lever to center position.
Turn key switch to “OFF” position.
TRANSPORTING MOWER
Never transport unit with engine running.
If transporting unattached from tow vehicle, remove spark plug wire and place it where
contact with the spark plug cannot be made.
SUGGESTED MOWING PRACTICES
Operate mower engine at full throttle to assure the best cutting performance and
maximum material discharge.
Allow wet grass to dry. Clumps of wet grass will collect under the mowing deck.
Mowing should be started with tow vehicle in low gear and increased only as safe
mowing conditions permit. This speed should not exceed 5 MPH.
The average lawn should be cut to approximately 2.5” during the cool season and to over
3” during the hot months.
For a healthier lawn and better aesthetics, your lawn should be mowed often and after
moderate growth.
When cutting high or dense grass areas go slowly. Some areas may need to be cut twice.
The second cut should be at 90 degrees to the first, if possible.
Never remove more than 1/3 of the grass length at any one time
GENERAL TROUBLE SHOOTING
The mower does not cut level.
o
Level deck, making sure height adjustments are equal.
o
Check air pressure of all tires; make sure they are equal (about 25-30 psi).
o
Check blade attachment.
The engine will not start.
o
Disengage blades, turn toggle switch to “OFF” position, check all electrical
connections, and inspect spark plug and wire.
Engine runs poorly.
o
See engine manual.
o
Check throttle adjuster.
o
Replace fuel, clean fuel filter and fuel line.
IF PROBLEMS PERSIST HAVE A QUALIFIED MECHANIC SERVICE THE
MOWER. NEVER ATTEMPT TO MAKE AN ADJUSTMENT THAT YOU ARE
NOT SURE IS CORRECT. DOING SO CAN CAUSE OTHER PROBLEMS.
8