Filter
Top Products
TOW HITCH OFFSET
• When offsetting the mower do so to the side opposite the discharge of the tow
vehicle.
• Swisher recommends if the tow vehicle is equipped with a mid-mount mower to
overlap the cut approximately 6”. This may vary depending on mowing terrain,
obstacles, and/or tow vehicle. Always keep safety the first priority.
• Always keep the tow vehicle cutter raised higher than the TrailMower.
• If the tow vehicle is not equipped with a mid-mount mower, we still recommend
offsetting the mower so that the tow vehicle does not crush the grass.
STARTING TO MOW
• Adjust the cutting height.
• Double check vehicle to mower attachment.
• Start mower engine and set throttle to “FAST” for best cutting performance.
• Slowly engage T-handle lever.
• Carefully mount vehicle and start mowing at a slow travel speed.
STOPPING THE MOWING SESSION
• Bring tow vehicle to a complete stop, set the parking brake and disengage blades.
• Turn engines “OFF”.
• Always remember to remove keys to avoid irresponsible usage.
SUGGESTED MOWING PRACTICES
• Operate mower engine at full throttle to assure the best cutting performance and
maximum material discharge.
• Allow wet grass to dry. Wet grass will clump and collect under the mowing deck.
• Mowing should be started with tow vehicle in low gear and increased only as safe
mowing conditions permit. Mowing speed should not exceed 5 MPH.
• Better results occur when mowing areas with the least amount of growth.
Although your TrailMower will cut through dense areas of growth you will
experience increased horsepower while mowing areas of less growth.
• For a healthier lawn and better aesthetics, your lawn should be mowed often and
after moderate growth.
•
Mowing conditions and the types of grass will vary from place to place. You may
find when mowing dense areas that the pressure of the wheel tracks may cause the
grass to be pushed down and not effectively mowed. If this happens you may
want to mow the area twice. Once with the mower raised and the second mowing
at the desired height. The second mowing should be at a right angle from the
previous for best results.
• Reducing the travel speed will help mow dense growth. This allows the blades
the time necessary to make its initial cut, and regain momentum to continue
cutting and discharging debris properly. The engine may stall if you are mowing
too fast!
•
Do not attempt to mow areas that the tow vehicle cannot maneuver through and/or
slopes that you do not feel comfortable riding.