Filter
Top Products
8
STANDARD HORIZONTAL TO VERTICAL
The Standard Splitter has 2 operating positions: Horizontal, Vertical.
Remove pin from below beam. Do not remove bolt and nut. Rotate beam into vertical position and pin
so beam cannot fall into horizontal position.
DO NOT TOW IN VERTICAL POSITION!
IMPORTANT:
When operating splitter in wooded areas, obtain a spark arrestor for the exhaust system.
See your local engine dealer.
When preparing logs, cut ends as square as possible. The maximum length of any logs should be only
24”.
MAINTENANCE & STORAGE
WARNING:
Disconnect spark plug before performing any maintenance or making adjustments.
RESERVOIR FLUID
Check the hydraulic fluid level in the reservoir tank before each use. Operating without an
adequate oil supply will cause severe damage to the pump. Change the hydraulic fluid in the
reservoir per manufacturers recommendations.
Be aware of the environment when disposing of used petroleum products. Please dispose of
used hydraulic fluid, engine oil and any by products from the maintenance of your log
splitter at approved recycling centers.
Should it become necessary to loosen or remove any hydraulic fitting or line, be sure to remove
all pressure by shutting off the engine and moving the control handle back and forth several
times.
NEVER remove the cap from the hydraulic tank or reservoir while your unit is running.
Hot oil under pressure will cause injury.
Always store gasoline in an approved, tightly sealed container. Store container in a dry, cool
place. Keep fuel away from gas appliances where fumes could contact open flame, pilot lights or
sparks.
Do not operate your splitter in poor mechanical condition or when needing repair. Repair and
replace worn or broken parts immediately.
Periodically tighten nuts, bolts, and hydraulic fittings.
The hydraulic system of your log splitter requires careful inspection, along with the mechanical
parts. Be sure to replace frayed, kinked, or otherwise damaged hydraulic components.
The pressure relief valve on the splitter is preset at the factory. Do not adjust valve. Only a
qualified service technician should perform this adjustment.
If the wedge becomes dull or nicked, it can be removed and sharpened. The wedge is heavy and
may still have sharp edges, wear gloves while handling the wedge.
REPAIR PARTS
Your Swisher Log Splitter has been produced with components designed specifically to this
machine. Although standard springs, hardware, etc. may look similar to parts used on other
machinery, they may in some cases be made of a different construction and/or materials.