Sunbeam FA7400 Outdoor Ceiling Fan User Manual


  Open as PDF
of 4
 
MARKETING
|
CREATIVE
|
PRINTING
|
DIGITAL&POS
19-21 Phillips Road Kogarah NSW 2217
T 02 9588 3655 F 02 9587 6741
P PO Box 447 Ramsgate NSW 2217
W visionmediagroup.com.au
E admin@visionmediagroup.com.au
9
Using your Tower fan (continued)
Using the remote control
1.Removetheremotecontrolfromits
compartment at the top of the tower by
applying downward pressure to the bottom
of the remote as shown.
2. Point the remote towards the control panel
on the front of the tower to operate.
TIMER
MODE
ON/OFF
OSC
ION
MODE
TIMER
SPEED
SPEED
SWING
ION
Changing the batteries
1. Open the rear cover off the remote control
unit.
2.Replacethespentbatterieswith2fresh
AAAbatteriesasshown.
3.Replacetherearcover.
Using the oscillation function
The70degreeoscillationfunctioncanbe
used on any setting.
1.Turntheunitonandselectanyfanspeed.
2. Press the
button on the tower control
panelortheremote.The'osc'iconwill
illuminate and the fan will begin to
oscillate from side to side.
Tostopthefanfromoscillating,simplypress
the button
once again.
Using the auto off timer
Theautoofftimerautomaticallyswitchesthe
fanoffafterapresetnumberofhours.To
activate this feature, simply press the auto
off timer button
on the tower control
panel or on the remote control unit.
1. Press the auto off timer button once to
switch the fan off after 1 hour.
2. Each subsequent press of the auto off
timer button will increase the number
of hours the fan will run before turning
off automatically by 1 hour increments.
Thedisplayscreenwillshowthenumber
of hours left before the fan turns off
automatically.
Tocancelthesetting,keeppressingthe
auto off button until it cycles past 12 hours,
to zero. It will then automatically return to
its normal setting displaying the ambient
roomtemperature.Theautoofftimerwillbe
deactivated and the fan will remain on until
it is switched off manually.
•Donotuseoutdoors.
•Donotrunthecordofthefanundercarpeting.
Donotcoverthecordwiththrowrugs,runners
orotherfloorcoverings.Arrangethecordaway
from traffic areas so that it will not be tripped
over.
•Donotusethisfanintheimmediatesurrounds
of a bath, shower, laundry area or swimming
pool.
•Besurethefanisplacedonadry,even
surface.Donotuseonsoftsurfaces,suchas
beds, where opening may become blocked.
•Keepyourfanawayfromheatsources,
corrosive gases and avoid direct sunlight.
•Thisfanisonlytobeusedwiththebasefitted
and in good condition.
•Disconnectthepowerplugbeforedismantling,
assembling or before cleaning.
•Alwaysunplugthefanwhennotinuseforany
long length of time.
•Thefanmustnotbeusediftheguardsare
damaged in any way.
•Donotinsertorallowforeignobjectstoenter
anyventilationorexhaustopeningsasthismay
cause electric shock or fi re, or damage to the
fan.
•Neverinsertfingers,pencilsoranyother
objectsthroughtheguardswheneverthepower
plug is connected, especially while running.
•Avoidtouchingmobilepartsofthefan.
•Donotattempttomoveyourfanwhilstitis
operating. If your fan needs to be moved,
please ensure that it is turned off and you use
the carry handle on top of the tower.
•Whenscrappingthefanattheendofitsuseful
life, follow local regulations.
Safety Precautions For
Your Tower Fan
2
8
Using Your Tower Fan
Switching the fan on
1. Place the fan on a flat level surface.
2.Inserttheplugintoa230/240Vpower
outlet and turn the power on.
3.Pressthepowerbutton
.
4. Press the fan speed button
to select
low, medium or high depending on your
preference.
Switching the fan off
• Toswitchthefanoff,simplypressthe
power button
.
•Ifyouwillnotbeusingthefanforalength
of time, it is advisable to turn the power
off at the wall socket and unplug the power
cord.
Selecting a fan speed setting
YourSunbeamtowerfanhas3speedsettings
as follows:
• lowspeed Displayscreenshows
2 vertical bars
•mediumspeed Displayscreenshows
4 vertical bars
•highspeed Displayscreenshows
6 vertical bars
Toselectafanspeed,simplypressthe
fan speed button
on the tower or the
remote. Each press of the button will
increase the fan speed and then return
back to the lowest speed again.
Locating Your Tower Fan
1.Alwayslocateyourfanonaflatlevel
surface.
2. Your tower fan should be located in a dry,
cool,wellventilatedlocation.Keepyour
fan away from heat sources, corrosive gases
and avoid direct sunlight.
3.Donotattempttomoveyourtowerfan
whilst it is operating. If your fan needs to
be moved, please ensure that it is turned
off and you use the carry handle at the rear
of the fan.
3
Black PANTONE 186 C FA7400_FA7400 Fan - Work-and-turn - Press Sheet 3 - Jul 20, 2011 2:01:54 PM
 previous