Filter
Top Products
LMM Owner’s Manual
-4-
ASSEMBLY
ASSEMBLE THE HANDLE SECTIONS (FIG. A)
Fit the lower section of the handle so that the holes are over the handle posts on the mower. Then
rock the handle to align the locking tabs and allow the handle section to fit into place.
Continue assembly of the middle and top sections of the handle using the handle bolts and wing
nuts.
ADJUSTING THE CUTTING HEIGHT (FIG. B, C)
The cutting height of the LMM may be adjusted from approximately 10 mm (.4 inches) up to
approximately 55 mm (2.1 inches). Actual height may vary according to the height of the turf.
Adjust the mower to the desired height as follows:
• Position the lawn mower on solid, level ground. Stand behind the lawn mower so that you can
put a foot on the roller (1) (Fig. B). Loosen both sets of screws (2). Now you can adjust the
desired cutting height with both hands using the adjusting handle (3) (Fig. C).
• Make sure the cutting height markers (4) indicate the same cutting height on the scales on both
sides. Now the two set-screws (2) should be tightened again.
OPERATION
INSPECT THE MOWING AREA
1. Before beginning to mow, remove any foreign objects, such as stones, branches, or toys, from
the area.
2. Continue to check for such obstacles during mowing.
Check within the blade area for any foreign objects and
remove them.
Do not o
p
erate the mower on areas other than turf.
!
WARNING