Filter
Top Products
Owner’s Manual — Sunlawn BTE-1
10
TRIMMER CORD BREAKAGE
If the cord breaks off at the spool it will not feed through
automatically. If this happens, do the following:
1. Detach the power connector cord from the battery pack.
2. Remove the card cartridge as described on pages 7-9.
3. Pull the transparent plastic ring over the trimmer cord spool.
4. The reel of trimmer cord is now open. Reel off approximately 10 cm
(4 inches) of trimmer cord and clamp it in the notch on the spool.
5. Thread the trimmer cord through the eye of the transparent plastic
ring and then replace the ring on the spool.
6. Replace the trimmer cord cartridge as described on pages 7-9.
CAUTION
Hold the lawn trimmer in the normal
working position before switching it on
again.
!