Filter
Top Products
The Stinger
®
Mosquito Vacuum is designed to be assembled
with NO tools. For additional questions on assembly, please
contact our Consumer Relations Department at 800-477-0457.
1. Attach Feet. Place Base on level ground. Insert Left Foot
(A) and Right Foot (B) into base (Figure 1).
2. Attach Upright Pedestals. Insert Left Upright Pedestal and
Right Upright Pedestal onto corresponding posts on base.
The ends with “U” cutouts should be at the top. Push down
to secure (Figure 2).
3. Attach the Vacuum Head. Align the left and right posts of
the Vacuum Head Assembly into the Left and Right Upright
Pedestals. Push down to secure (Figure 3).
4. Select and place the Mosquito Vacuum in the optimum
location. Refer to the following MOSQUITO VACUUM
PLACEMENT section for recommendations.
5. Place Propane Tank on Base. Place a full 20 lb tank of
propane on the base. The threaded connection should be
facing the handle area on the trap (Figure 4).
6. Attach the Gas Regulator Valve to the Propane Tank.
Remove the protective plastic cap from the threaded hose
connection on the propane tank and attach regulator, turning
clockwise to tighten. Note: The hose fitting must be
securely hand tightened to prevent gas leakage (Figure 5).
ASSEMBLY INSTRUCTIONS
Figure 3
Figure 3
Figure 5
Figure 1
Figure 2
Figure 2
Figure 4
Figure 4
5
CT100_OM.qx 2/9/07 2:19 PM Page 5