5
ENGLISH
GB
SYMBOLS
The following symbols are displayed on the ma-
chine in order to remind you about the safety pre-
cautions and attention necessary when using the
machine.
The symbols mean:
Warning!
Read the instruction book and safety man-
ual before using the machine.
Warning!
Do not put hands or feet under the cover of
the machine when it is running.
Warning!
Beware of objects being flung out. Keep
spectators away.
Warning!
Before starting any repair work, remove the
spark plug cable from the spark plug.
INTRODUCTION
ThismowerdeckcanonlybeusedforParkma-
chines with a motor output of at least 16 hp.
The mower deck is available in two versions as
standard:
- with mechanical setting of the mowing height
(art. no. 13-2915)
- with factory-fitted, electrical setting of the
mowing height (art. no. 13-2921).
PREPARATIONS
Park models up to 1993:
A modification must be made to the machine to use
the mower deck:
1. Dismantle the return spring for centre steering
(fig 1).
2. Saw off the spring bracket, level with the frame
side member (fig 2).
3. Drill a new hole (Ø 8 mm), 8 mm from the lower
edge of the frame side member (fig 3).
4. Fit the spring in the new hole (fig 4).
ASSEMBLY
MOWER DECK
1. Bolt the mower deck to the attachment brackets D
(fig 5a).
2. Then hook the lower S-hook on to the mower
deck (fig 5b-c).
3. Connect the electrical contact to the outlet on the
side of the machine (applies only to art. no. 13-
2921), (fig. 6).
V-BELT
1. Set the height adjustment to an intermediate posi-
tion.
2. Lift the mower deck using the attachment lift.
3. Pull the v-belt over the machine's central belt pul-
ley F (fig 7).
4. Tension the belt using the tension roller G. The
tension roller should be on the left of the belt seen
from the operator's position.
5a. Park -1999:
Hook the tension roller spring H into the floor on the
right hand side (fig 7).
5b. Park 2000- :
Hook the tension roller spring H into the fastener,
just behind the front right wheel (fig 7).
SETTING
For the attachment to mow evenly and cleanly it
needs to be adjusted correctly:
1. Make sure the tyre pressure is correct:
Front: 0.6 bar (9 psi).
Rear: 0.4 bar (6 psi).
2. Place the machine on a flat surface. Loosen the
screws I (fig 8).
3. Adjust the mower deck so that the casing's front
and rear edges are the same height from the floor.
4. Tighten the screws.
USE
MOWING HEIGHT
The mowing height may vary from 30 to 80 mm:
- art. no. 13-2915 has seventeen fixed mowing