Filter
Top Products
ENGLISH
GB
SYMBOLS
The following symbols appear on the machine.
They are there to remind you of the care and atten-
tion required in use.
This is what the symbols mean:
Warning! Read the Instruction Book and
Safety Manual before using the machine.
Warning! Keep onlookers away. Beware
of objects being flung out.
Warning! Do not insert your hands or feet
under the deck when the machine is in op-
eration.
Warning! Before starting any repair work,
remove the spark plug cable from the
spark plug.
Warning! Always tilt the lawn-
mower backwards when cleaning
the underside. Petrol and oil can
run out if the lawnmower is tilted
in the other direction.
IMPORTANT
Certain models do not have throttle control. The
engine’s speed is set for optimal function and min-
imal exhaust emissions.
ASSEMBLY
HANDLE
Fold up the lower part of the handle.
Then attach the upper part of the handle. This is at-
tached with screws, washers and locking wheels
(fig. 1).
The handle has four different positions. Release
the catch with your foot and set the handle in de-
sired position (fig. 2).
1. For normal mowing.
2. For mowing under trees, bushes, etc.
3. Parking position.
4. Delivery and storage position. The handle takes
up less space if the knobs are released and the
handle folded up.
NOTE! Check that the wires are not caught or bro-
ken when the handle is unfolded or folded.
CONTROLS
Install the wires and electric cable (Multiclip 46
SE) in the cable holders E (fig. 3). Secure the start-
er handle in lug F on the right hand side of the han-
dle.
BATTERY (Multiclip 46 SE)
The electrolyte in the battery is toxic
and corrosive. It can cause serious cor-
rosion damage etc. Avoid all contact
with skin, eyes and clothing.
Before starting for the first time the battery should
be charged for 24 hours, see further information
under the heading MAINTENANCE, BATTERY.
USING THE MOWER
BEFORE STARTING
FILL THE CRANKCASE WITH OIL
The lawnmower is delivered without
any oil in the engine crankcase. The
crankcase must be filled with oil before
the engine is started for the first time.
1. Remove the oil dipstick (fig. 5, 6, 7).
2. Fill the engine’s crankcase with 0.55 litres of
good quality oil (service class SE, SF or SG).
Use SAE 30 or SAE 10W-30 oil.
3. Slowly fill to ‘FULL/MAX’. Do not overfill.
CHECK THE OIL LEVEL
Check before using the machine that the oil level is
between ‘FULL/MAX’ and ‘ADD/MIN’ on the
dipstick. The mower should stand level.
Briggs Stratton:
Remove and wipe off the dipstick (fig. 5, 6). Slide it
down completely and tighten it. Unscrew and pull it
up again. Read off the oil level. If the oil level is low,
fill with oil up to the ‘FULL/MAX’ mark.