Filter
Top Products
6
ENGLISH
GB
MOWING TIPS
Always mow so the cable is laid out behind you on
the grass (fig. 6).
Never cross the cable! Should this hap-
pen by accident, stop the motor, pull out
the plug and check if the cable is dam-
aged.
Before mowing the lawn, take care to remove any
stones toys and other hard objects.
A machine with MULTICLIP system cuts the
grass, chops it finely and then blows it down in the
lawn. The grass clippings need not to be collected.
The following rules should be observed to give
best MULTICLIP effect:
1. Do not cut the grass too short. Not more than 1/
3rd of the length should be cut off.
2. Always keep it clean under the mower casing.
3. Always use a well sharpened blade.
4. Avoid mowing when the grass is wet. The grass
then sticks to the underside of the casing, giving
poor mowing results.
CUTTING HEIGHT
Do not set the cutting height so low that
the blade/blades can hit uneven ground.
When adjusting the cutting height - al-
ways first disconnect the plug.
The cutting height can be adjusted to 4 positions by
moving the wheel axles (fig. 7).
Position 1 = Lowest cutting height
Position4=Highestcuttingheight
CLEANING
In order to function properly the engine must be ef-
fectively cooled. This is done by a fan which sucks
in air at the air intake on the engine casing (fig. 8).
To make sure that the cooling system functions
properly the air intake must be thoroughly cleaned
if it has become blocked.
The machine should be cleaned each time after
use. For best possible mowing results it is impor-
tant that the underside of the chassis is kept clean.
Use a brush or blow with compressed air.
The machine must not be washed down with water.
MAINTENANCE
CHANGING BLADES
You must never service the motor or the lawn
mower before first shutting off the motor and pull-
ing out the plug.
Use protective gloves to prevent cuts when chang-
ing blades/knifeblades.
Blunt and damaged blades tear off the grass and
spoil the look of the lawn after mowing. New, well
sharpened blades cut the grass cleanly, so that the
lawn looks green and fresh even after mowing.
To replace the cutting blades, slacken the screw us-
ing the enclosed blade wrench. Fit the new blade
so that the punched STIGA logotype on the blade
is facing upwards towards the chassis (not down
towards the grass). Refit the screw and tighten to
20 Nm.
When replacing the blade, the blade screw should
also be replaced.
The guarantee does not cover damage to the blade,
blade holder or engine caused by running into ob-
stacles.
When replacing the blade, the blade holder and
blade screw, always use original spare parts. Non-
authentic spare parts could lead to the risk of per-
sonal injury or damage, even if they fit the ma-
chine.
SHARPENING OF THE BLADES
Sharpening of the blades must be done by wet
method grinding, using a whetstone or a grind-
stone.
For the sake of safety, the blades should not be
sharpenedonanemerywheel.Averyhightemper-
ature could cause the blade to become brittle.
Once the blade has been sharpened, it
must then be balanced so as to avoid vi-
bration damage (fig. 10).
STORAGE
Thoroughly clean the mower and store it indoors in
a dry place.