Stiga 45 S COMBI Lawn Mower User Manual


 
9
ENGLISH
GB
2. If the lawn mower is left unattended to, remove
the lead from the spark plug. Also remove the
starter key (*).
If the start/stop loop no longer works,
stop the engine by removing the lead
from the spark plug. Immediately take
the lawn mower to an authorised work-
shop for repairs.
REAR WHEEL DRIVE (*)
Engage the drive by pressing coupling clamp I
against the steering handle. Disengage the drive by
releasing coupling clamp I (fig. 10).
CUTTING HEIGHT
Shut off the motor before adjusting the
cutting height.
Do not set the cutting height so low that
the blade/blades can hit uneven ground.
The mower is fitted with a single lever control for
adjusting the cutting height. Pull the lever out-
wards and adjust the cutting height to the position
which is most suitable for your lawn (fig. 11).
NOTE! When the machine is used for "Multi-
clip", the two lowest cutting heights must not be
used. The "Multiclip" function does not work if
the grass is cut too short.
MAINTENANCE
Neitherthemotornorthelawnmower
may be serviced before the ignition ca-
ble is removed from the spark plug.
Stop the motor and remove the spark
plug cable if the mower is to be lifted,
e.g. with transportation.
If the lawn mower needs to be tilted it
should be tilted so that the spark plug
face upwards. Tilt the lawn mower when
the fuel tank is empty.
CLEANING
After each time it is used the mower should be
cleaned. This is particularly important on the un-
derside of the mower casing. Wash out with the
garden hose. The mower will then last longer and
function better. Note! High pressure washing units
should not be used.
If grass has dried on to the cutterhead casing it can
be removed by scraping. If necessary, give the un-
derside a touch of paint to prevent rusting.
Clean the silencer and the surrounding
area regularly to remove grass, dirt and
flammable waste products.
You should clean the inside of the drive wheels (*)
once every season. Remove both wheels. Brush or
blow-clean the gear and the wheels' gear ring from
grass and dirt. Refit the wheels (fig. 12).
PROTECTIVE GRILLE
Clean the protective grille F to remove any grass
and dirt after each time the machine is used to pre-
vent the engine from becoming damaged as a re-
sult of overheating (fig. 13, 14).
COOLING SYSTEM
The engine is air-cooled. Grass and dirt can easily
clog the cooling system and damage the engine.
The cooling system should be cleaned at least once
a season or after every 100 hours of operation.
Clean more often if you mow in dry grass.
Briggs & Stratton model. LS45:
Remove the three screws A (fig. 13) and lift away
the fan housing. Clean the area inside the line (fig.
15).
On LS45 engines, the screws A can be more easily
reached if the engine cover is removed first.
Briggs & Stratton model. ES40:
Remove the protective grille and clean the marked
area (fig. 16).
LUBRICATING THE DRIVESHAFT (*)
You should grease the key on the driveshaft once
every season. Remove the wheel (hub cap, screw
and washer). Then remove the E-circlip and wash-
er to enable the gear to be removed from the shaft.
Grease the key with universal grease.
Refit the key (different key fitments on right- and
left-hand sides, see fig. 17, 18). Install the gear so
that the L mark will be facing outwards on the left-
hand side, and the R mark facing outwards on the
right-hand side (mower viewed from behind).