Filter
Top Products
1.12
ASSEMBLING THE MOWER
Remove the mower from the packaging and check that the following
items have been supplied correctly. If any items are missing contact,
your local Hayter dealer.
1. Grassbag. 2. Grassbag Frame.
To prevent accidents cut off the long ribbon attached to the grass-
bag and discard.
Unscrew the handlebar securing knobs sufficiently to allow the handle-
bar to pivot. Move the engine stop lever away from the engine to avoid
damage and unfold the handlebar to the operating position. Make sure
the knobs are assembled to the outside of the handlebar and tighten to
secure in position.
Take care to ensure that the control cables do not become snagged at
the pivot point.
(1) Insert metal frame into grassbag fabric and (2) Clip into position.
Raise the rear deflector, lower the grassbag through the handlebar and
hook in position. Lower the deflector to rest on the grassbag.
Handlebar
Delivery Checklist
Grassbag Attachment
1
2
Grassbag Assembly
111-1102 (B) 11/11/08 9:56 am Page 1.12