Filter
Top Products
19
Section 4 - MAINTENANCE
4.6 DECK REMOVAL
(Continued From Previous Page)
4. Rotate spring loaded hitch latch pins (Located
on both hitch plates) to the unlatched position.
See Figure 4.10.
5. Move deck lift switch as if to lower deck and
the lift arm will move up in the hitch plates. The
lift arm needs to be high enough to clear the
hitch plates when power unit is driven backward
away from mower deck. See Figure 4.9.
6. Pull lock collar back and slide power transfer
shaft away from power take off (PTO) shaft. See
Figure 4.11.
7. Disconnect wiring harness from mower deck.
8. Start power unit. Disengage parking brake.
Carefully move power unit backward away from
mower deck.
FIGURE 4.10
FIGURE 4.11
4.7 POWER TRANSFER SHAFT REMOVAL
Engage parking brake. Turn engine “OFF” and
remove key. The power transfer shaft connects the
power unit to the mower deck. The shaft is
telescoping for easy removal. Slide locking collar
back toward mower deck and shaft will slide off.
See Figure 4.11.
WARNING
DO NOT attempt any adjustments, maintenance or
service with the engine or blades running. Stop
blades. Stop engine. Set brake. Remove key.
Remove spark plug wires from spark plugs and (gas
only) secure wires away from spark plugs. Engine
and components are HOT. Avoid serious burns by
allowing all parts sufficient time to cool.
NOTE: DECK LIFT ARM SHOWN REMOVED FOR
CLARITY. DECK WOULD NOT BE REMOVED AT THIS
TIME IN DECK REMOVAL PROCEDURE.
HITCH LATCH PIN SHOWN IN
UNLATCHED POSITION
HITCH
PLATE
POWER
TRANSFER
SHAFT
LOCK COLLAR
PULL LOCK
COLLAR
BACKWARDS
POWER
TAKE OFF
SHAFT